6
SPRINTER MOBIL - HYMAX PRO 08.12.2015 20110005 OPI
•
Improperly done repairs.
• Catastrophic cases due to foreign inluences or
force majeure.
2
General information
Technical documentation contains important in-
formation for safe operation and for retaining
functional safety of the system.
•
To verify system set up, the set up protocol form is
to be signed and sent to the manufacturer.
•
Forms are available in this inspection book for
use in verifying single, regular and extraordina-
ry safety checks. Use the forms to document in-
spections and leave the completed forms in the
inspection book.
•
The system master forms must record changes to
the construction and changes to set up location.
2.1 Set up and test the system.
Safety relevant work on the system and safety
inspections may only be done by personnel speci-
ically trained to carry it out. They are designated
in general and in this documentation as technical
experts and specialists.
•
Technical experts are people (freelance expert
engineers, TÜV specialists) that may inspect and
assess due to their education and experience
with lift systems. They are knowledgeable in the
appropriate work safety and accident preventi-
on regulations.
•
Specialists (competent people) are people who
have suficient knowledge and experience with
lift systems and have participated in a special
factory training by the system manufacturer.
2.2 Hazard information
To become aware of the hazardous points and
important information, the following three symbols
are used with the descriptive meaning. Pay parti-
cular attention to text positions that are labeled by
these symbols.
i
Note! Labels information about a key function
or points to an important remark!
!
Caution! identiies a warning of possible system
damage or other operating company property
damage if the highlighted process is not done
properly!
Danger !
identiies a danger to life
and limb, if the highlighted process
is not done properly there is a mortal
danger!
3
Safety regulations
When working with systems comply with legal
accident prevention regulations according to
BGG 945, inspection of lifts; BGR 500 and operation
of systems; VBG 14.
Particular attention is drawn to compliance with the
following regulations:
•
When operating the system, follow safety regula-
tions and operating instructions in the operating
manual.
•
The total weight of the accepted load may not
exceed
- 2,500 kg for SPRINTER MOBIL 2500 - HYMAX PRO
2500 and
- 3,000 kg for SPRINTER MOBIL 3000 - HYMAX PRO
3000,
where a maximum load distribution of 3:2 or 2:3
in or against the drive-in direction is permitted.
•
Only personnel aged 18 or over may operate
systems independently, they must be trained in
system operation and have their work veriied by
the company. They must be explicitly tasked with
operating the system (excerpt from BGR 500),
see transfer protocol.
•
Operation of the system is only permitted on a
smooth, solid surface.
•
During lifting or lowering, the work area of the
system should be clear or people.
•
It is prohibited from moving people with the lift.
•
It is prohibited to climb onto the system.
•
After design and maintenance on load bearing
parts the system must be inspected by a techni-
cal expert.
•
Initial access into the system may only be done
after the main switch (2) is off and locked.
• For vehicles with low loor clearance or custom
equipment, check in advance whether it could
be damaged.
•
Consider any possible centre of mass shifts when
disassembling heavy vehicle components.
