Operating / P-Level
44
January 2006 / Rev. 1.0
SELFTEST
CONTINUED
SERIAL I/O TEST
Master Board serial interface (SUB-D9 connector)
can be checked. (Only with additional test-plug).
SWITCH TEST
Switches and sensors can be tested in this menu.
Activating a switch by hand should change the
displayed state. Following switches are shown:
Logic Door, Drop Door, Billbox Door, Hopper Count
Switch, Hopper High Level, Jackpot Key, Audit Key.
OPTOBOARD TEST
Test checks coin channeling optics (light barriers).
Select channel
to hopper or to drop box and insert
coin. When the coin has passed the optics the
displayed color changes from yellow to red.
HANDLE TEST
Option not used.
BUTTON TEST
In this menu panel buttons, service buttons and
Master Board buttons (service & reset) can be
checked. Displayed color changes from yellow to red
as a button is pressed. The 4 menu navigation
buttons can not be tested with button test.
EEPROM TEST
Starts an internal EPROM test.
BILL-ACCEPTOR STATUS
The current status and operation mode of bill
acceptor and stacker is displayed.
BILL-ACCEPTOR DIAGNOSTICS
In this menu bill acceptor statistics are shown and
the acceptor can be tested. Tests are only available,
if the bill acceptor is initialized. With JCM™
acceptors only "Validator test w. stacking" and
"Validator test w/o. stacking" is available.
MONITOR MAGNETIC STATE
Displays a complete red screen to check monitor
for color purity and uniformity. Check monitor
degaussing coil, if the screen is not uniformly red.
Note:
Manufacturer use. Additional
test equipment needed.
to hopper
to drop box
SERVICE MENU
IIC-PORT DRIVER CHECK
VOLTAGE CHECK
COIN DIVERTER CHECK
TOPLIGHT TEST
DIPSWITCH SETTINGS
SOUND TEST
LAMP TEST
SERIAL I/O TEST
SWITCH TEST
OPTOBOARD TEST
HANDLE TEST
EEPROM TEST
BILL-ACCEPTOR STATUS
BILL-ACCEPTOR DIAGNOSTICS
MONITOR MAGNETIC STATE
RGB-COLOR TEST
CHECKSUM
MAIN-COMMBOARD TEST
C-BOARD SPEED HANDSHAKE
ALINK STATUS
TOUCH STATUS
QUIT
BUTTON TEST
BUTTON PANEL
GREEN BUTTON
RED BUTTON
MAINBOARD
