ATouch User Guide
6
Chapter 2 Touchscreen Installation
2.1 CRT Monitor Installation
CRT monitor installation process as following steps :
1.
Incoming inspection
x
CRT monitor : please check if the monitor works well.
x
Touchscreen : please unpack the touchscreen, connect your
touchscreen with the controller on your PC and test if the
touchscreen works well.
x
After testing the monitor and touchscreen, you can start to install
touchscreen into your monitor by the following steps.
2.
Disassembling CRT monitor
x
Remove the back side plastic housing of your CRT monitor.
x
Discharge the CRT tube from the front bezel (usually there are 4
screws on the 4 corners need to be released).
x
Check if the electronic board needs to be removed or not.
x
Verify the fit position on the CRT tube for the touchscreen.
x
After verifying the position, you can attach the touch sensor onto
the CRT. You can use the double side high tack adhesive tape (as
3M) to attach the touch sensor onto the CRT display
x
After this process, check the space between the touch
sensor and the front bezel. If the space is not enough, you may
need to add rubber spacers between the touch sensor and the front
bezel ( the 4 corners on which the CRT and the front bezel is
