Atos Medical TheraBite, Manual, Page: 15 / 78

15
1.6 PRECAUTIONS
• Do not sterilize the TheraBite. Sterilization processes may
weaken the TheraBite and it may break during use.
• Always handle the TheraBite with care; it may break during
use if damaged due to rough handling.
• Do not apply too high force on the Mouthpieces. They are
designed to break if too much force is applied during use in
order to avoid injury to the jaw.
2. Instructions for use
Before the first use, the maximum opening of the TheraBite
appropriate for each individual user should be determined by
the clinician.
2.1 Preparation
Setting Maximum Opening of the Jaw Mobilizer
Maximum openings of approximately 25 to 45 millimeters
can be set either by the position of the Range Setting Arm or
the position of the Fine Adjustment Knob. The TheraBite can
be used without adjusting these settings, depending on the
user’s ability to understand and implement instructions for
the application of appropriate pressure.
Adjust the Range Setting Arm (Fig. 6-7)
• Hold the device on its side.
• Use a pointed object (such as a pen) to move the pin that
connects the Range Setting Arm to the Lever (Fig. 7a & 7b).
• Align the Range Setting Arm in the desired position and
replace the pin. (Range change is approximately 5 mm per
interval.)
The scale on the Jaw Mobilizer is for reference only. Use the
Range of Motion Scale for more accurate reference.
2.2 Operating instruction
Before each use check that the device is undamaged. Do not
use the device if it is damaged.
Put on the Bite Pads (Fig. 8-9)
Always make sure that the Mouthpieces are completely dry
before attaching the Bite Pads.
• Peel off the liner (Fig. 8).
• Attach one Bite Pad to the Upper Mouthpiece and one to
the Lower Mouthpiece (Fig. 9).
• Apply pressure with your fingers to ensure proper adhesion
to the Mouthpieces. Pressure and warmth under a prolonged
period will make the Bite Pads stick better.
To enhance adhesion of the Bite Pads, attach the Bite Pads to the
Mouthpieces before going to bed and leave them on overnight.
The adhesive bond on the Bite Pads increases over time, the
longer they are attached prior to use, the more strongly they
will tend to adhere.
Replace the Bite Pads when they become worn. Additional
Bite Pads can be ordered separately.