51
Appendix
Gigaset SL560 / Aton CL303 / SWZ PTT EN / A31008-M1710-F151-1-7619 / appendix.fm / 10.7.06
Appendix
Care
¤
Wipe the base station, charging cradle
and handset with a
damp
cloth (do not
use solvent) or an antistatic cloth.
Never
use a dry cloth. This can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
1.
Switch off the handset and remove
the battery pack immediately
.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place
for at least 72 hours
(
not
in a microwave, oven etc.).
4. Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
Faults and Self-help with
Troubleshooting
Not every fault is due to a defective
phone. In certain circumstances, it can
come from a brief interruption in the
power supply to the base station (unplug/
plug in power supply) or if the batteries of
the handset are removed and inserted
again. The following instructions should
be of help for specific faults.
I
mportant:
problems or faults can only be
remedied if you bring the complete unit
(base station, handset, as well as connect-
ing cable) to the place of purchase.
!
The display is blank.
1. The handset is not switched on.
¥
Press and
hold
the end call key
a
.
2. The batteries are flat.
¥
Charge or replace the batteries (page 5).
The handset does not respond to a key press.
The keypad lock is activated.
¥
Press and
hold
the hash key
#
"Base station x"
flashes
in the display.
1. The handset is outside the range of the base
station.
¥
Reduce the distance between handset/
base station.
2. The handset has been de-registered.
¥
Register the handset (page 35).
3. The base station is not switched on.
¥
Check the base station mains adapter
Base Search flashes in the display.
The handset is set for
Best Base
and no base sta-
tion is switched on or within range.
¥
Reduce the distance between handset/base
station.
¥
Check the base station mains adapter
Handset does not ring.
1. The ringtone is switched off.
¥
Activate the ringtone (page 41).
2. Call diversion set to
All Calls
.
¥
Switch off Call Diversion (page 16).
You cannot hear a ringtone/dialling tone.
Base station's phone cord has been replaced.
¥
When purchasing a new cord, ensure that it
has the correct pin connections (page 6).
The other party cannot hear you.
You have pressed the
u
(INT) key. The hand-
set is "muted".
¥
Switch on the microphone again (page 13).
The incoming call number is not displayed
although CLIP is set
.
Phone number identification is not enabled.
¥
Caller
should ask network provider to acti-
vate phone number identification (CLI).
