4
Atomik-RC.Com
Rally 9100 | SCT 9101
sw
sw
sw
TRANSMITTER ADJUSTMENT
Your Brian Deegan Metal Mulisha Model comes with the
receiver pre-bound to the transmitter from the factory. Should
you need to re-bind the receiver to the transmitter or you get
new components, follow these steps to ensure proper
communication between the transmitter and receiver.
1) Turn ON the transmitter.
2) Plug in battery to the 2:1 ESC/Receiver. Leave switch OFF.
3) Remove vehicle wheels or place vehicle on a stand to prevent
a run-away model during the binding process.
4) Press and hold the Bind button on the 2:1 unit. While holding
the Bind button, turn ON the 2:1 unit. The flashing red LED
should turn solid red when binding is complete.
5) Turn 2:1 unit OFF and then back on again to ensure the binding
process was successful. Repeat steps 1-3 if necessary.
Binding the Transmitter and Receiver
Low Battery Alarm
THROTTLE TRIGGER
THROTTLE TRIGGER
STEERING
STEERING WHEEL
Neutral
Left
Brake / Speed Down
Forward / Speed Up
Neutral
Right
Turn the steering wheel counterclock-
wise to turn left, turn the steering
wheel clockwise to turn right.
1. Push the trigger foward to slow down or brake.
2. Pull the trigger backward to accelerate.
Throttle Trim: Position the throttle trigger at the neutral position, adjust the throttle trim accordingly.
Steering Trim: If the front wheel does not align straight, use the steering trim to make adjustments.
(Red Line)
(Red Line)
(Red Line)
(Black Line)
(Black Line)
(Black Line)
Connect to battery
Red Line <+> Black Line <–>
Servo
Antenna
1. Turn on the receiver power.
Press the SW switch. The
receiver’s LED should start
flashing.
2. Turn on the transmitter.
3. When the LED on the
receiver becomes solid, the
binding process is complete.
