7
3 - USES
I - SETTINGS
Starting:
Before switching on your device, connect the cable network (type RJ45) to the connector (10). For
reasons of stability of the network, the wired connection is preferred to Wifi binding when possible.
Press the standby key: the led (21) flashes about 8 seconds before the display appears. Wait for the first
page on display before handling.
You can then use the buttons (19) forward navigation on your remote control or the front panel to access the
menus.
When first plugging in your device (or in the case of changing network configurations),
you must set up the connection between your Streamer and your network. Without this
configuration, the operation of internet radios, or playback of the files present on your
network will be inoperative.
Network settings:
Go in the 'Settings' menu and then on 'network '.
Select the menu « Network setup ».
Then you’ll have to choose between « wired » or « wireless ».
1/ In the case of a wired connection, the display shows that the system will restart in
cable mode. If it is not already, connect the network cable and then press OK. The unit
will restart (wait several seconds).
You can pass to automatic (DHCP) or even enter a static IP address.
2/ In the case of a "wireless" connection, the device will help you find available wireless
networks. To do this, press "scan". All of the wireless networks available in your
environment will be shown, Select the one corresponding to your.
RQ: in some environments (buildings), several networks can be visible. Make sure
you choose yours.
WPS key: Enter, in accordance with the capital letters and no spaces the security key WIFI which appears at the
bottom of your internet emitter. In some cases it is required to set your emitter in association mode to secure the
connection.
In the seconds that follow press 'Play' on your remote control or press and hold 2 seconds the Centre key on the
keypad of the front panel of your Streamer The connection to the network only takes a few seconds and it
remains in memory even when the Streamer or the emitter have been disconnected.
This symbol indicates the link wireless as well as the strength of the signal.
