3
mounTing sysTem
the Atn night vision riflescopes mounting System allows to change the position of the rif-
lescope flexibly on the weapon in relation to a shooter in combination with the fixed positions
already available on the weaver rail. For this purpose in the base of the mounting bracket
there is a rail with a fixing projection. there are three grooves in the mounting bracket for
mounting this rail. Besides it is possible to change the position of the riflescope additionally
by 1/3 of inch. For doing this one needs to about-face the rail.
to change the position of the riflescope on the
weaver rail additionally follow the steps men-
tioned below:
1. Unscrew the two screws, which attach the
rail to the mounting bracket.
2. take the rail out of the groove.
3. About-face the rail in case of necessity.
4. place the rail into another groove.
5. Fix the rail with the two screws.
NOTE:
If the rail is not taken out easily, screw
up tight one of screws into the threaded aper-
ture in the middle of a fixing projection of the
rail. Continue rotation of the screw. Thus the
screw will push out a rail from a groove.
Focusing
to focus your riflescope you will need to adjust the diopter
first thing. Simply turn the diopter clockwise until it stops.
then, while looking through the diopter at a subject, slowly
turn the diopter back counter clockwise until the grain in the
image is sharp.
NOTE:
We suggest that you focus the diopter during day-
light with the filter on.
next, focus the front lens until the image and the grain are
both sharp. When you are in the low-light conditions and the
daylight filter is off you may focus the front lens to receive a
sharp image, the diopter should not be adjusted.
NOTE:
The front lens should be readjusted as you view objects at different distances.
windAge And eleVATion
the vertical and horizontal adjustments for the Aries can be
achieved by turning the elevation and windage adjustment
mechanisms (remove dust caps first). each click equals to
1/4 inches at 100 yards. When reaching the maximum of
rotation do not use force.
brighTness AdjusTmenT
By rotating the “r” handle you may adjust the reticle’s bright-
ness. Adjustment could be easily seen if you look thought the
scope while adjustment.
retICLe BrIGHtneSS ADjUStment
WInDAGe
eLevAtIOn
±5 DIOpter ADjUStment
FOCUSInG SyStem
WeAver
rAIL
GrOOveS
rAIL WItH A FIXInG
prOjeCtIOn
SCreWS
