Atmospheric Water Systems dewpoint DH9, Owner'S Manual

Page: 15 / 46

11
operation
Turning on the Dewpointe
The Dewpointe automatically turns on when plugged in. •
The LCD Monitor will immediately light up. •
The system will remain unlocked for 10 seconds. You can modify the factory presets if you choose to. •
The compressor will turn on after 2 minutes. •
NOTE: Heating and cooling elements will not activate until the Allot level has reached ‘3’. This may take up to a day depending on water
disbursement, temperature and humidity.
Changing the Hot and Cool water settings
To change factory presets, you must unlock the system by holding down the Unlock/Power Button to enter
Program Mode. You may turn off the Hot and Cool Water elements by pressing the
Hot and Cool Buttons. The
circular icons next to the thermometers will become unlit on the LCD screens.
NOTE: DO NOT leave the Hot Water element on without activating the Cool Water element. This may cause undesired warming of the cool
water tank. You may turn the Heating Element off and leave the Cold Water Element on.
Setting the Hot and Cool water temperature (DH9 only)
Press and hold the 1. C/F Button until the Hot Water Temperature display starts flashing.
Use the 2. Hot and Cool Buttons to raise and lower the temperature of the hot water.
Press the 3. C/F Button again to change the temperature of the cool water. The Cool Water Temperature display
will start flashing.
Use the 4. Hot and Cool buttons to raise and lower the temperature of the cool water.
NOTE: The Hot and Cool water setting will automatically exit after 10 seconds of no activity
Operation