User Guide & General Maintenance
Rainier Summit R1
8
1-888-MY-AIR11 CAG-06-21-002 AtmosAir.com
Operating Instructions
Congratulations on your purchase of the AtmosAir Rainier Summit R1
portable air purifier. The Rainier uses state of the art bi-polar ionization
technology and high efficiency filtration to provide cleaner healthier indoor
air. The following guide will provide you with instructions on how to properly
setup and use your unit so you may enjoy its benefits for many years.
Package Contents
After unpacking the Rainier be sure the following are included in the
package:
The Rainier R1 Unit w/ Replaceable Filter
Power Plug Adapter
Warranty Registration Card
User Instructions
Spare Fuse
Choosing a Location
The Rainier R1 was designed to be able to purify an area up to
square
feet (
P
)
DWDLUFKDQJHSHUKRXURUVTXDUHIHHWPDWDLU
FKDQJHVSHUKRXUIRUVSDFHVVXFKDV
O
arge bedrooms,
offices, kitchens,
family rooms, etc. The best place to locate the unit is
4’
to
7’ (1.2
to 2.1
meters) off the floor in a central area within the room you de-sire to purify.
For example a desk, table, shelf or other suitable space.
The
unit should
never be placed on the floor as it will not be able to purify effectively
.
The unit should never be placed in an unsteady spot as dam-age to the unit
may occur if it falls. Also please never let the unit become wet as damage
to the unit may occur.
Unit Setup
After you
’
ve placed the unit in a suitable spot, simply plug into a standard
wall receptacle. The unit comes with a universal wall plug which can
accommodate multiple wall plug adapters. Simply snap on the wall plug
adapter included with the unit to the universal wall plug. Turn the On / Off
switch on the rear to the On position. The power light (1) will come on
indicating the unit is powered and ready for use. If the unit does not power
on, check the troubleshooting steps included in this guide.
Maintaining Your Unit
The Rainier R1 will require maintenance at certain intervals to ensure
optimal performance and protection against premature wear. There are 2
main components that will need periodic replacement, the system filter and
the bi-polar ion tube.
The system filter is intended to capture dust and dirt and chemical
contaminants. The R1 is equipped with a high efficiency pleated filter to
help filter out dust and particles which is impregnated with carbon to help
capture gasses and odors
Warning—Before attempting any service to the unit be sure the
unit is switched off and power plug is disconnected!
To replacethe filter, simply remove the filter which is located at the rear of
the unit, by first pulling upward and then outward and replace with the new
filter.
Be
sure to place the new filter in snugly and to note you are
placing the filter in the correct orientation, by noting the airflow direction
arrow on the side of the filter.
Inside the unit on the filter holder frame, there is a small power defeat
switch to ensure the unit cannot operate without a filter installed. When
installing the new filter be sure to place the new filter tightly down so that
good contact is made and the switch remains down so the unit can operate.
Replacement filters packs come in a quantity of three (3). These can be
purchased from the AtmosAir reseller where you purchased your Rainier.
The filters for this unit are custom designed for the unit and are only
available from an AtmosAir reseller.
System Filter
Maintining Your Unit
continued
Be sure to place the new filter in snugly and to note you are placing the filter in the correct orientation, by noting the airflow direction
arrow on the side of the filter.
Inside the unit on the filter holder frame, there is a small power defeat switch to ensure the unit cannot operate without a filter
installed. When installing the new filter be sure to place the new filter tightly down so that good contact is made and the switch
remains down so the unit can operate.
Replacement filters packs come in a quantity of three (3). These can be purchased from the AtmosAir reseller where you
purchased your Rainier. The filters for this unit are custom designed for the unit and are only available from an AtmosAir reseller.
