MISSION2 User Manual
1.3 Removing/replacing the strap
In addition to the originally provided long straps, MISSION2 has
short straps available for purchase. If you need to adjust the
length of the strap, you can replace strap according to the
following instructions.
Change watch strap:
When removing the strap, push the strap spring clip to the
right, lift it up to take out the strap, and release the strap spring
clip. To replace a new strap, simply follow the opposite steps.
* The strap is a consumable item and when it must be replaced
with a new strap, you can make a purchase through the
dealer or directly at ATMOS.
1.4 Basic Operation
1.4.1 Button Function:
Press button A: Up/ view Smart Notifications
Hold button A: Quick mobile phone Bluetooth On/Off
Press button B: Menu and Confirm
Press button C: Down/ Widget
Hold button C: access Stopwatch
Press button D: Return/ Setting
Press button E: Turning backlight On/Off.
Hold button E: Power Off
1.4.2 Power On/Off
Power On: Press and hold backlight button E for 3 seconds, or
connect MISSION2 to the charging cable.
Power Off: Press and hold button E for 3 seconds while in watch
mode.
1.4.3 Charging
Please make sure the charging points are clean and dry.
Moisture and dirt can seriously affect charging efficiency and
may cause damage. Please use a power adapter with safety
certification (rated voltage: DC 5V/2A)
※
Do not use connectors or fast chargers that exceed the
rated voltage: DC 5V/2A. It will affect the lifespan of the battery.
Please ensure the charging cable is properly connected when
charging. If the charging position is not aligned, it may result in an
improper connection and cause the watch to overheat. It takes 2
hours to fully charge, and the screen will display 100%.
※
The lithium battery in MISSION2 can be damaged if not fully
discharged. MISSION2 has an internal protection mechanism
which will disconnect the battery before it is fully discharged.
However, a small amount of discharge will still occur. If it is left
4
