Atmel AVR STK100, User Manual

Page: 22 / 34

STK100 Starter Kit User Guide 7-1
Section 7
Menu and Option Descriptions
7.1 File Menu
7.1.1 Load Select Memory Area/buffer window to load (Flash or EEPROM), then open the “Intel
Hex” file in the “Open File” dialog box. A red status warning light indicates that the file
load was unsuccessful. This may be because the file is not Intel hex or it is too large for
the selected buffer/memory.
7.1.2 Save Saves the contents of the selected buffer (Flash or EEPROM) to file. Choose a filename
in the “File Save” dialog box that appears.
7.1.3 Reload Reloads the buffer (Flash or EEPROM) with the last file opened.
7.1.4 Exit Quits the program. Standard Windows close choices can also be used to exit the
program.
7.2 Device Menu
7.2.1 Erase The whole device is erased.
7.2.2 Program The selected device memory, fuses or lockbits are programmed.
7.2.3 Read The selected device memory or fuses are read.
7.2.4 Verify The selected device memory is verified against the buffer contents.
7.2.5 Run Takes target device out of programming mode and into normal run mode. The user will
be prompted to switch jumpers to run mode.
7.2.6 Fuses Presents the user with a list of available programmable fuses on the device and allows
the user to write and read these fuses if the device supports the program.
7.2.7 Auto Program All operations selected in the “Auto Program Options” are carried out.
7.2.8 Auto Program
Options Dialog box to set required programming operations that will be carried out sequentially
when “Auto Program” is pressed.