Atmel AT43DK370, User Manual

Page: 10 / 57

Getting Started
2-2 AT43DK370 USB Host/Function Dev. Kit User Guide
3423C–USB–1/04
2.4 Connecting the
Hardware
Atmel has taken great care in creating a reliable demonstration kit for its customers. In
order to ensure proper operation, the supplied components in the kit must be used in the
setup as shown in Figure 2-1. Atmel does NOT recommend substitution of these
components.
Figure 2-1. Connection to the AT43DK370
Connect the AT43DK370 evaluation board as follows:
1. Connect the serial cable from J5 on the evaluation board to a COM port on the
PC.
2. Connect the AC input connector of the power supply to an AC wall outlet
(110 VAC).
3. Connect the DC output connector of the power supply to J1 on the evaluation
board.
2.5 Installing
AT43DK370 and
Starting Up the
USB Clinic
To install the AT43DK370:
1. Insert the “Atmel AT43DK370” CD into the CD-ROM drive of the PC or notebook
and follow the instructions.
2. After installation, the AT43USB370 documents, firmware, and software should
be installed on the C:\Program Files\ATMEL USB\AT43DK370 , if the default
installation directory is used. One of the software programs installed is USB
Clinic. It is an integrated diagnostic and debugging tool that provides communi-
cation between the AT43DK370 and the PC. Please refer to Section 4 of this
User's Guide for detailed description of this tool.
3. To invoke the USB Clinic program from desktop go to Start > Programs > Atmel
USB Clinic > Atmel USB Clinic. The screen in Figure 2-2 will appear.
J1
J5
Power Supply
(5VDC)
110VAC
Outlet
AT43USB370DK Evaluation Board
RS232
Cable