AT-UHD-HDVS-300-KIT
12
1. Connect up to two UHD/HD sources to the
HDMI IN 1
and
HDMI IN 2
ports.
2. Connect a VGA source to the
VGA IN
port.
3.
Connect up to two USB host devices to the
USB 1
and
USB 2
ports, using USB A/B cables. Both USB 1.1 and
USB 2.0 are supported.
4.
OPTIONAL: Connect a 3.5 mm mini-stereo cable from the
AUDIO
port to an analog audio source. Making this
connection will allow audio to accompany the source connected to
VGA IN
.
5.
OPTIONAL: Connect the included 3-pin captive screw connector block from the
RS-232
port to an automation
control device. This port provides pass-through control of the RS-232 device connected to the AT-UHD-HDVS-
300-RX.
6.
Connect up to two USB devices (e.g. keyboard, mouse device, etc.) to the
USB HUB
ports. Both USB 1.1 and
USB 2.0 are supported. Maximum current draw for this hub is 1.5 A. Maximum current draw for both transmitter
and receiver is 2.5 A.
7. Connect an Ethernet cable from the
HDBaseT OUT
port to the
HDBaseT IN
port on the AT-UHD-HDVS-300-RX.
Ethernet cables should use EIA/TIA-568B termination.
8.
Connect an Ethernet cable, up to 330 feet (100 meters), from the
LAN
port to the Local Area Network (LAN).
An automation control system can also be connected to the network, allowing pass-through IP control to an
IP-controlled device connected to the AT-UHD-HDVS-300-RX. Connecting this port to the LAN will also provide
access to the built-in web GUI. Refer to
for more information. Ethernet cables should
use EIA/TIA-568B termination.
1. Connect an HDMI cable from the
HDMI OUT
port to a UHD/HD display.
2. Connect an HDMI cable from the
HDMI IN 5
port to a UHD/HD source.
3.
OPTIONAL: Connect the included 3-pin captive screw connector block from the
RS-232
port to an RS-232
device. This port provides both pass-through control from the automation control system, connected to the AT-
UHD-HDVS-300-TX, or display control to the device connected to the AT-UHD-HDVS-300-RX.
4.
Connect up to three USB devices (e.g. keyboard, mouse device, etc.) to the
USB HUB
ports. Both USB 1.1 and
USB 2.0 are supported. Maximum current draw for this hub is 1.5 A. Maximum current draw for both transmitter
and receiver is 2.5 A.
5. Connect an Ethernet cable from the
HDBaseT IN
port to the
HDBaseT OUT
port on the AT-UHD-HDVS-300-TX.
Ethernet cables should use EIA/TIA-568B termination.
6.
Connect an Ethernet cable, up to 330 feet (100 meters), from the
LAN
port to the Local Area Network (LAN).
An automation control system can also be connected to the network, allowing pass-through IP control to an
IP-controlled device connected to the AT-UHD-HDVS-300-RX. Connecting this port to the LAN will also provide
access to the built-in web GUI. Refer to
for more information. Ethernet cables should
use EIA/TIA-568B termination.
7. Connect the included power supply to this port using the included 2-pin captive screw connector. Refer to
Connection Instructions
Installation
Transmitter
Receiver
