AT-HDR-M2C
33
The AT-HDR-M2C includes two mounting brackets,
which can be used to attach the unit to any flat surface.
Use the two enclosure screws, on the sides of the unit to
attach the mounting brackets.
1.
Using a small Phillips screwdriver, remove the two
screws from the left side of the enclosure.
2.
Position one of the mounting brackets, as shown
below, aligning the holes on the side of the enclosure
with one set of holes on the mounting bracket.
3. Repeat steps 1 and 2 to attach the second mounting
bracket to the opposite side of the unit.
4.
Mount the unit to a flat surface using the oval-shaped
holes, on each mounting bracket. If using a drywall
surface, a #6 drywall screw is recommended.
Mounting Instructions
NOTE:
Mounting brackets can also be
inverted to mount the unit under a table or
other flat surface.
Appendix
