13
ASSEMBLY INSTRUCTIONS
FIG.1:
On a flat surface, lay the Main Frame (1) down. Attach Front Base (2) and Rear Base (3) to the Main Frame (1)
and secure them into place using Hex Bolts (18), Washers (19) and Nylon Lock Nuts (20).
Insert one Plastic Bumpers (47) into the hole of the Leg Extension Arm (11).
Fully fasten this hardware assembly, as shown above.
FIG.2:
Insert two Guide Rods (60) into the receptacles
located on the Main Frame (1) and secure them into place
using two Deep Head Screws (76).
Lubricate the Guide Rods with silicone or teflon lubricant,
then slide two Rubber Bumpers (62) onto each Guide Rod,
as shown.
Attach Acclivitous Support (4) to the Main Frame (1) and
secure it into place using two Hex Bolts (18), four Washers
(19) and two Nylon Lock Nuts (20).
Do not completely fasten this hardware assembly at this
time, as it will be completely fastened later in the assembly
process.
Warning: This procedure requires the assistance of another person.
