14
FIG.3:
Insert Selector Bar (68) into the Plastic
Bushing (66), and insert the Pin (67) through the
hole of the Bar and Bushing, then insert the
assembly and the Round Cap (65) into the Top
Plate (64).
Note: These Parts have been assembled at our
factory.
FIG.4:
Carefully begin sliding the Weight Plates (63) over the Guide Rods (60).
Warning:
Do not lift more than you can control safely. In addition, do not lift using only your back. It is recommended that
when you are lifting, bend your knees and lift slowly with your back straight. Be sure that the weight is distributed over
your knees or legs when lifting. Also, it is advisable to wear a well fitted lifting belt during heavy lifting.
Slide the Top Plate/Selector Bar over the Guide Rods allowing it to come to rest on the completed weight stack.
FIG.5:
Attach the Top Cross Beam (8) to the Acclivitous
Support (4) and secure it into place using two Hex Bolts (18),
four Washers (19) ,Link Plate (23) and two Nylon Lock Nuts
(20). Next, maneuver each of the Guide Rod (60) into the
holes located on the Top Cross Beam (8), and secure it into
place using two Hex Bolts (34) and two Washers (35).
Attach Support Bar (10) to the Acclivitous Support (4) and
secure them into place using two Hex Bolts (16), four Washers
(19) and two Nylon Lock Nuts (20).
Proceed to align and fully fasten this hardware assembly and
all the previous assemblies that were left loosely fastened.
