Owner’s Manual
F6-AMIX
Multi-Function Analog Mixer Card
AtlasSound.com
– 4 –
Specifications are subject to change without notice.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800.876.3333 • Fax: 800.765.3435
WARNING: When The Device Is In Use
• To prevent electric shock, do not remove the product cover as there are high voltage components
inside. Refer all servicing to Atlas Sound.
• Should any of the following irregularities occur during use, immediately switch off the power,
disconnect the power cord from the AC outlet and contact Atlas Sound. Do not to attempt to
continue operation with the product as this may cause fire or electric shock:
• Smoke or strange smell coming from the unit.
• If the product falls or the case is damaged.
• If water or any metallic objects falls into the product.
• If the power supply cord is damaged in any way.
• If the unit is malfunctioning.
• Do not insert or drop metallic objects or flammable materials into the ventilation holes of the
product's cover, as this may result in electric shock or fire.
• Do not place any containers with liquid or metallic objects on the top of the product. If any liquid
spills into the unit, fire or electric shock may result.
• Never operate this product or touch the power supply cord during an electrical storm, electric
shock may result.
• Never exceed the power rating on the product when connecting equipment. Fire and/or property
damage may result.
• Operate the product only with the voltage specified on the unit. Fire and/or electric shock may
result if a higher voltage is used.
• Do not modify, kink, or cut the power cord. Do not place the power cord in close proximity to
heaters and do not place heavy objects on the power cord, including the product itself, doing so
may result in fire or electrical shock.
• Replace the protective cover over the speaker terminals after installation. Do not touch the 70V
speaker terminals as electric shock may result.
• Ensure that the safety ground terminal is connected to a proper ground. Never connect the ground
to a gas pipe as a catastrophic disaster may result.
• Be sure the installation of the product is stable, avoid slanted surfaces as the product may fall and
cause injury or property damage.
CAUTION: When Installing The Product
• Plugging in or unplugging the power cord with wet hands may result in electric shock.
• Never move the unit with the power cord plugged into the wall, as damage to the power cord may
result.
• When unplugging the cord from the wall, grasp the plug, NOT the cord.
• Never install this product in humid or dusty locations, nor in direct sunlight, near sources of heat,
or in areas where sooty smoke or steam are present. Fire and electric shock may result.
• Keep all sides of the unit at least 31⁄2" away from objects that may obstruct air flow to prevent the
unit's internal temperature rise.
