REV. 01 2012
23 / 35
6.4.5.2 CORRECTION OF OUTER SIDE
x
Apply the weight onto the position indicated by
the arrow shown on the screen (ref. fig. 41)
following the same procedures for correction of
inner side.
x
In case that the unbalanced amounts are left on
the outer side of the rim, it is advisable to perform
SPLIT function.
6.4.6 SPLIT FUNCTION
The SPLIT function is used to position the adhesive weight behind the wheel spokes so that they are
no longer visible. It is advisable to use this function only in the ALU
ƿ
modes.
To start the SPLIT function, in ALU1
ƿ
or ALU
ƿ
mode
select and press SELECTOR, and do as follows:
x
Choose the first spoke of two adjacent spokes
where is unbalanced.
x
Move the first spoke to the 12 o
’
clock position.
x
Press SELECTOR to memorize the position. A
green soft-dot will be shown on the screen to
mark the first split point (ref. fig. 44).
x
Choose the second spoke of two adjacent spokes
where is unbalanced.
x
Move the second spoke to the 12 o
’
clock position.
x
Press SELECTOR to memorize the position.
Another green soft-dot will be shown on the
screen to mark the second split point (ref. fig. 45),
and in the meantime the original red dot
disappears on the screen.
Fig. 41
Fig. 44
Fig. 43
Fig. 45
Summary of Contents for WB55
Page 1: ......
Page 35: ...REV 01 2012 35 35 CHAPTER 12 ELECTRIC DIAGRAM...
