Atlas Copco Dynapac F1800C, Operation & Maintenance Manual

Page: 231 / 318

F 40.18 9
Outer auger bearing (4)
The grease nipples are located on
each side at the top of the outer
auger bearings.
These nipples must be lubricated at the
end of work to force out any bitumen res-
idues which may have entered and to
supply the bearings with fresh grease
when warm.
A
If the auger is extended, the outer rings
should be loosened slightly when initially
greasing the outer bearing points in or-
der to improve ventilation on greasing.
The outer rings must be properly se-
cured again after greasing.
A
New bearings must be filled with
60 strokes of grease using a grease gun.
Mounting screws -
outer augur bearing
Check tightening (5)
m
Following the running-in period, the
tightening torques of the outer auger
bearing mounting screws must be
checked.
- Tighten to the following torques
if necessary:
- (F): 210 Nm
m
If the auger's working width is changed,
the tightening check must be repeated
after the running-in period!
6x
C