Atlas Copco Dynapac F1800C, Operation & Maintenance Manual

Page: 117 / 318

D 10.18 43
Item Designation Brief description
52
Indicator lamp
hydraulic filter Lights up when the hydraulic filter needs replacing.
A
Replace filter element acc. to Maintenance Instructions!
53
Indicator lamp
Hydraulic oil tem-
perature
m
Lights up if the hydraulic oil temperature is too high.
Stop the paver finisher when if the temperature is too
high (drive lever in centre position), let the engine cool
down while idling. Determine the cause and correct it
if necessary.
54
Oil pressure indi-
cator lamp for the
diesel engine (red)
m
Lights up when the oil pressure is too low.
Switch off the engine immediately!
For further possible faults, see Engine’s operating in-
structions.
55
Indicator lamp
"Main function
switch" /
"Start inhibit"
- Lights up when the function is switched on.
- Indicates that an enabled function stops the machine from
starting.
A
Press the corresponding function switch to switch off
the start inhibit for maintenance work. However, the
start function is prevented and the indicator lamp is
switched on again at the next attempt to start
the vehicle.
A
On restarting, the function is set to "ON".
56
Indicator lamp
"Filling function"
Lights up when the function is switched on.
A
The indicator lamp goes off when the driver lever is
swivelled out.
57
Indicator lamp
"Set-up mode"
- Lights up when the function is switched on.