Atlas Copco Dynapac F1800C, Operation & Maintenance Manual

Page: 216 / 318

F 31.18 2
Danger of being pulled in by rotating or conveying
vehicle parts
Rotating or conveying vehicle parts can cause severe or
fatal injuries!
- Do not enter the danger zone.
- Do not reach into rotating or conveying parts.
- Only wear close-fitting clothing.
- Comply with the warning and information signs
on the vehicle.
- Stop the engine and remove the ignition key before any
maintenance work.
- Comply with all further information in these instructions
and in the safety manual.
Danger from heavy loads
Lowering vehicle parts may cause injuries!
- When the vehicle is parked and during maintenance and
transport, close both hopper lids and fit the correspond-
ing hopper transport safeguards.
- When the vehicle is parked and during maintenance and
transport, raise the screen and fit the corresponding
screed transport safeguards.
- Ensure that opened hoods and covering parts are
locked properly.
- Comply with all further information in these instructions
and in the safety manual.
Hot surfaces!
Surfaces including those behind covering parts, together
with combustion gases from the engine or screed heater
can be very hot and cause injuries!
- Wear your personal safety gear.
- Do not touch hot parts of the vehicle.
- Only perform maintenance and repair work after the
vehicle has cooled down.
- Comply with all further information in these instructions
and in the safety manual.
WARNING
CAUTION
CAUTION