ENG
29
1.8 Front Panel Explanations
On the front panel You can found 3 LED for an easy diagnostic or an LCD panel.
LED
Information
Main Switch
[
]
Press the UPS On/OFF [
] Switch for approx. 3
seconds, then the Buzzer sounds twice, the UPS will be
start-up.
To enable “DC-Start” Function when Utility fails. (To
enable DC Start properly, you are recommended to
connect <80% output load with the UPS only). P.S.
Make sure the computer connected to the UPS is
switched on before enable the "DC-Start" function. You
are not recommended to add some other computer or
peripherals after DC-Start function is activated.
LED Line (
)
Green LED remains standstill when Utility is normal.
LED Inverter (
)
Lit and simultaneously buzzer alarms (every 2 seconds)
when Utility failure (also the LED
). The buzzer
alarms every seconds when UPS is in battery low
condition.
Fault LED (
)
Red LED remains standstill when UPS is fault.
Red LED flashes when UPS is in AVR mode.
Summary of Contents for OnePower 1001
Page 1: ......
