![background image](http://html1.mh-extra.com/html/atlantis/miglide-mg2-small/miglide-mg2-small_fitting-instructions-manual_3000486007.webp)
7
Any revisions must first be approved by the product designer. Version: 201909
Revision By: JST
25.
A small bead of silicon should be applied to the
junction between
top track and glass
panel as indicated.
26.
Clear silicone should be used to seal the end
connector channel to
the glass return panel.
This will ensure that
the top track cannot
move on the glass
panel.
27.
DOOR SEAL (optional)
Fit the bulb seal onto
leading edge of door,
if required.
28.
FITTING TOP TRACK DETAIL STRIP
3x detail strips have been supplied with this
product. Select desired colour/finish. Install into
the recess into the top track. Sand the reverse
face of the acrylic to allow for adhesion. Apply 2
x 3mm beads of silicone to front face of top
track. Place the detail strip in recess and tape
into place. Allow silicone to cure for 24 hours
before
removing the
tape.
Place the spare detail strip on top of the top
track. This will cover the adjustment holes. Do
not silicone into place.
ELLURE WALL FINISHING TRIM
When this system has been supplied with Atlantis
Ellure Tile Look Walls an additional 6mm acrylic strip
has been supplied. The wall channel should be
positioned to the outside edge of the finishing trim.
Run a small continuous bead of silicone in the recess.
Push the 6mm acrylic trim into the remaining space.