5
Any revisions must first be approved by the product designer. Version: 201909
Revision By: JST
14.
When the idle rollers are being fitted to hangers
apply a 5mm drop of clear silicone inside the
thread. This will ensure that the hanger does
not move out of adjustment.
15.
TOP TRACK
Slide the idle rollers into
the top track as per
diagram.
16.
END CONNECTOR MG-3W
Fix MG-3W end connector bracket flush with the
end of the top track using supplied 4x 6#x10CSK
screws.
Fixed
Panel
this end
17.
END CONNECTOR ANGLE (MG-2W)
Fix the MG-2W end connector angle into place.
Screws should be left
slightly loose.
18.
TOP TRACK AND DOOR PLACEMENT
Stand inside the
shower and
manouver the
pre-assembled
door and top
track inside the
shower.
Carefully lift the
top track with
the door
attached into place over the return panel
20
MGF.
The top track will sit on the wall channel
on the fixed panel side and the MG-2W end
connector angle will slide over the glass return
panel. Ensure the top track is level. Fix the MG-
3W end connector bracket to the wall. Tighten
the screws into the end connector angle firmly.
