1.3
Software Deployment
The HyperScale Configuration Wizard automatically creates storage volumes across all of the nodes in
your appliance. Use the storage volumes to provision your application VMs.
Procedures are given for the following hypervisors:
•
Citrix XenServer
•
VMware vSphere
1.3.1
Citrix XenServer
To configure your Atlantis HyperScale appliance with XenServer:
1.
Power on each node and let it boot until the XenServer configuration wizard is visible.
2.
After all four nodes have booted, connect a Windows system to the same physical management
networking switch as the HyperScale appliance.
3.
Temporarily configure the Windows system with the following network settings:
•
Static IP address: 192.168.8.200
•
Netmask: 255.255.255.0
•
Gateway: no gateway
4.
On the Windows system, start a browser and connect to: http://192.168.8.150:8082.
5.
Click
Begin
to start the Atlantis HyperScale configuration wizard.
6.
On the second page of the configuration wizard select or enter values for the following
configuration settings:
•
Keyboard layout.
•
Timezone.
•
NTP Server IP address.
•
Management password. This sets the HyperScale Manager Administrator (
admin
) and
hypervisor root password.
Click
Next
.
7.
On the third page of the configuration wizard select or enter values for the following
configuration settings:
•
Host names for the four Atlantis HyperScale nodes.
•
Management network configuration:
o
Enter an IP address range that contains at least 20 IPv4 addresses. These IP addresses
must be routable from the console you will use to manage the Atlantis HyperScale
appliance.
o
Netmask.
o
Gateway.
o
Comma-separated list of DNS servers (for example, 10.0.1.4, 10.72.1.4). If the list does
not contain a running DNS server product installation will fail.
