Atlantis HyperScale Installation Guide for HP ProLiant DL360 Gen9
© 2015 Atlantis Computing, Inc. All Rights Reserved.
10
•
Storage network configuration:
o
Enter an IP address range that contains at least 20 IP v4 addresses. These IP addresses
do
not
need to be routable.
o
Netmask for the storage network.
o
Gateway for the storage network. (Usually not required. Leave blank if not required).
8.
Review the information and if everything is correct click
Submit
to apply the configuration. All
nodes will be rebooted, so verify that there are no USB flash drives in the hardware appliance.
The installation process takes approximately 20 minutes to configure networking and complete
the installation and configuration of Atlantis HyperScale software.
9.
To monitor the installation progress, wait a few minutes after clicking
Submit
to let the
HyperScale Manager boot up and then log into the HyperScale Manager. Open a browser and
point it to the fifth IP address in the management IP address range. Username =
admin
,
and
the password is the password you specified in step 6.
10.
Point your browser to the first IP address in the management network IP address range, and
download and install the XenCenter application to manage the appliance.
11.
The installation is finished when all three Hyper-Converged All Flash volumes are created. Log in
and view the Volume Dashboard to confirm that the volumes were created.
