Atlantis A03-OP1001-RC, User Manual

Page: 93 / 107

ENG
93
The code is show as 27/28 and
the icon is lighting on LCD
display and alarm is
continuously sounding.
Battery voltage is too
high(27)/low(28) or the
charger is fault.
Contact Atlantis.
The icon and
is flashing on LCD display and
alarm is sounding every 2
seconds.
UPS is overload. Remove excess loads
from UPS output.
UPS is overloaded.
Devices connected to
the UPS are fed directly
by the electrical
network via the Bypass.
Remove excess loads
from UPS output.
After repetitive
overloads, the UPS is
locked in the Bypass
mode. Connected
devices are fed directly
by the mains.
Remove excess loads
from UPS output first.
Then shut down the
UPS and restart it.
The code is show as 43 and the
icon is lighting on LCD
display and alarm is
continuously sounding.
The UPS shut down
automatically because
of overload at the UPS
output.
Remove excess loads
from UPS output and
restart it.
Fault code is shown as 14 and
the icon is lighting
on LCD display and alarm is
continuously sounding.
The UPS shut down
automatically because
short circuit occurs on
the UPS output.
Check output wiring
and
if connected
devices are in short
circuit status.
Fault code is shown as 1, 2, 3, 4
11, 12, 13, 41 on LCD display
and alarm is continuously
sounding. A UPS internal fault has
occurred. There are two
possible results:
1. The load is still
supplied, but directly
from AC power via
bypass.
Contact Atlantis.