Atlantis A03-OP1001-RC, User Manual

Page: 70 / 107

ENG
70
2.3 Setup The UPS
Step 1: UPS input connection
Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using
extension cords.
Step 2: UPS output connection
Simply plug devices to output sockets. During power failure, UPS will provide power
to connected devices.
For socket-type outputs, there two kinds of outputs: programmable outlets and
general outlets. Please connect non-critical devices to the programmable outlets and
critical devices to the general outlets. During power failure, you may extend the
backup time to critical devices by setting shorter backup time for non-critical devices.
Step 3: Communication connection
Communication port:
To allow for unattended UPS shutdown/start-up and status monitoring, connect the
communication cable one end to the RS-232 port and the other to the communication
port of your PC. With the monitoring software installed, you can schedule UPS
shutdown/start-up and monitor UPS status through PC. All models are equipped with
intelligent slot perfect for SNMP (A03-SNMP1-IN), RS-232, USB card. When installing
with these communication card in the UPS, it will provide advanced communication
and monitoring options.
PS. USB port and RS- 232 port can’t work at the same time
.
Remove cover of intelligent slot, Insert communication card into the slot and finally
Screw card tightly and complete installation.
Step 4: Network/Phone
Connect a single modem/phone/faxline into surge- protected “IN” outlet on the back
panel of the UPS unit. Connect from “OUT” outlet to the equipment with another
modem/fax/phone line cable.