ATIKA KGSZ 255, Operating Manual

Page: 22 / 167

21
The electrical connection or repairs to electrical parts of
the machine must be carried out by a certified electrician or
one of our customer service points. Local regulations – es-
pecially regarding protective measures – must be ob-
served.
Repairs to other parts of the machine must be carried out
by the manufacturer or one of his customer service points.
Use only original spare. Accidents can arise for the user
through the use of other spare parts. The manufacturer is
not liable for any damage or injury resulting from such ac-
tion.
Description of device
1 Carrying handle
2 Carrying handle with On/Off switch
3 Protective cover
4 Carbon brush cover
5 Pendulum cover
6 Saw blade
7 Work piece stop
8 Rotary table
9 Table insert
10 Indicator for mitre angle
11 Scale for mitre angle
12 Base
plate
13 Support arm
14 Wing screw for support arm
15 Wing nut for vice assembly
16 Vice
assembly
17 Indicator for incline angle
18 Scale for incline angle
19 Set screw for 90° saw head incline
20 Incline
locking lever
21 Laser
22 Dust
bag
23 Exhaust neck
24 Stop plate
25 Set screw for the cutting depth
26 Set screw for 45° saw head position
27 Battery compartment for laser
28 Transport
locking pin
29 Set screw for the pulling device
30 Locking lever for the rotary table adjustment
31 Set screw for work piece stop
32 Motor
33 Lock for pendulum cover
34 Saw blade locking device
35 Set screw for the saw blade position
36 Carbon
brush
37 Hexagonal screw for saw blade mounting
38 Front saw blade flange
39 Reducing
washer
40 Rear saw blade flange
41 Spanner
Preparing for commissioning
Inserting the batteries
ƒ Open the battery compartment (27)
ƒ
Insert two batteries of the type Micro LR03 (AAA, not in-
cluded) and observe the specified polarity.
ƒ
Close the battery compartment again (27).
Loosen the transport locking pin before first use and after each
transport:
ƒ
Slightly push the handle down
ƒ
Pull out the transport locking pin (28)
L To achieve flawless functioning of the machine, please
follow the instructions listed:
ƒ Place the machine at a location that meets the following
conditions:
−
secured against slipping
−
free of vibrations
−
even
−
free of tripping hazards
−
adequate light
ƒ To ensure a safe position of the saw it must be bolted down
on a solid surface (e.g. workbench or support frame) at opti-
mal working height:
−
Disengage the transport locking pin
−
Make 4 holes in the support matching the holes in the
base plate.
−
Bolt the device down.
ƒ Before each use, check
−
Connection cables for defects (cracks, cuts, etc.)
Do not use any defective cables.
−
the saw blade for flawless condition
ƒ
Do not use deformed or damaged saw blades.
ƒ
Immediately replace a worn or damaged table insert.
ƒ Connect the mitre crosscut saw to a dust collection device
when cutting wood.
Commissioning
L
Mains connection
Compare the voltage listed on the device type plate, e.g. 230 V,
with the mains voltage and connect the device to the corre-
sponding and proper socket.
P
P
P
P
O
A