ENG - Manual of installation, use and maintenance.
210-0352_libretto_WHC_ATI_eng.docx
8
Jan-19
9.
THE INSIDE OF THE APPLIANCE
The following instructions will show the internal components of the heating boiler, their configuration and maintenance.
Remove the frontal casing of the appliance to carry out these interventions.
1.
remove the screws from both the left and right side, by means of a common screwdriver (not supplied);
2.
remove the screws from the lower part of the appliance;
3.
paying attention to the upper gland, unscrew the nut on the opposite side of the sheet, so to push the cable out of the
sheet slot, then leave the cable free;
4.
it is now possible to remove the whole front bonnet by means of the handles on both sides of the appliance.
To reassemble the bonnet, follow the instructions in reverse.
PAY ATTENTION TO THE STEEL RIMS, BECAUSE THEY MAY BE SHARP: THE USE OF PROTECTIVE EQUIPMENT IS RECOMMENDED.
THE MANUFACTURER DOES NOT ASSUME ANY RESPONSIBILITY FOR POSSIBLE INJURIES.
