Manual, Flexdeburr, RC‑660 Series
Document #9610‑50‑1017‑10
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 USA • Tel: +1.919.772.0115 • Fax: +1.919.772.8259 • www.ati‑ia.com
26
Table 6.1—Troubleshooting
Symptom
Cause
Resolution
Secondary burrs
are created on work
piece after cut
Incorrect feed rate
Reduce feed rate.
Too heavy a cut
Decrease width of cut/make multiple passes.
Improper Bur selection
Choose bur designed for work material. Refer to
.
Bur is worn
Inspect bur if worn, replace. Refer to
.
Motor bearings are
worn.
Inspect spindle shaft, if shaft feels loose or has
play, replace. Refer to
Chip packing of bur
Too heavy a cut
Decrease width of cut/make multiple passes.
Not enough chip
clearance
Use a bur with less flutes.
The bur stalls
Not enough or no drive
air
Check drive air regulator for 90 PSI (6.2 Bar) and for leaks.
Bur is not secure in the
collet.
Properly tighten bur in collet. Refer to
.
Too much side load
Decrease width of cut and make multiple passes.
The turbine motor
needs to be replaced.
Replace the turbine motor. Refer to
The motor spindle
is sticking.
The motor bearings are
worn.
Replace the turbine motor. Refer to
