ATI Technologies FireGL X3-256, User Manual

Page: 15 / 54

Detailed Installation 9
Installing the Card
1
Turn off the computer, monitor, and other peripheral devices.
2
Unplug the computer’s power cord and disconnect all cables from the
back of your computer.
3
Remove the computer cover.
If necessary, consult your computer’s manual for help in removing the
cover.
4
Unscrew or unfasten and remove any existing graphics card from
your computer.
Note: If your computer has an on-board graphics capability, you may
need to disable it on the motherboard. For more information, see your
computer documentation.
5
Locate the appropriate slot and, if necessary, remove the metal back-
plate cover.
6
Align your ATI graphics card with the slot and press it in firmly until
the card is fully seated.
7
Remove the power cable from the hard drive power connector.
8
Connect the power extension cable to the 4-pin power connection on
the graphics card.
9
Connect the power extension cable to the power supply .
10
Connect the power extension cable to the hard drive.
11
Screw in or fasten the graphics card securely. Make sure the cables
are not interfering with anything inside the computer (for example, a
cooling fan) and replace the computer cover.
12
Reconnect any cables you have disconnected and plug in the
computer’s power cord.
L
WARNING
- Wait approximately 20 seconds after unplugging the
power cord before disconnecting a peripheral or removing a
component from the motherboard to avoid possible damage to the
motherboard.
L WARNING
- Remember to discharge your body’s static electricity by
touching the power supply or the metal surface of the computer
chassis.