FOR TRANSPORT
1. Position the machine on a trailer or other
vehicle (See Figure 27).
2. Stop the engine.
3. Lower the Preseeder until the rotor rests
on the deck.
NOTE:
The attachment must be fully low-
ered during transport or the frame may be
damaged.
4. Use the front tie down loops on the bot-
tom of the wheel frame to secure the front
of the machine.
5. Secure the rear of the tractor using the tie
down loops as shown
NOTE:
Do not over tighten the tie down
straps or the frame or tires may be dam-
aged.
DETACHING PRESEEDER TILLER
FROM TRACTOR
1.
Turn off Tractor engine and lower rotor to
ground.
2.
Remove Main Drive Belt Shield by
removing 2(two) mounting bolts
(See
Figure 30 on Page 18 ).
3.
Move Drive Belt Release Handle to the
disengaged position, and remove belt from
Drive Pulley (D) on engine (See Figures
31 & 32 on Page 18).
4.
Remove 2(two) 1/2 inch attaching bolts
(See Figure 28).
REVERSE ORDER FOR ATTACH-
ING PRESEEDER TILLER TO
TRACTOR
PRESEEDER OPERATION
16
FIGURE 27 Transport Tie Downs
FIGURE 28 Attaching Bolts Preseeder to Tractor
Summary of Contents for Preseeder 365
