Athena 6075 series, Instruction Manual, Page: 9 / 39

SECTION 2 INSTALLATION INSTRUCTIONS
2.1
Unpacking
Unpack the instrument and inspect for shipping damage. Report any
damage to the carrier immediitely.
2.2 Locating
Select a location for the controller where it will not be subject to excessive
shock vibration, dirt moisture or oil. The ambient temperature of the area
should be between 3 2 º and 131 º F (A model DC-15 dust, oil and water resis-
tant cover is available to protect from harsh environments.)
2.3
Mounting
Mount the controller into a 92 mm (3 5/8”) square cutout See figure for the
cutout and case dimensions. The plug-in controller does not have to be
removed from its housing for mounting. Remove two screws that hold the
mounting slides and then remove the slides. Insert case from front panel
and re-install the two slides and two screws. Do not over-tighten screws. The
length of the slides must be reduced if the controller is to be mounted in an
extra thick panel. If the controller has been unplugged from its housing, the
top of the housing can be determined because it features the serial tag.
2.4
Removing Unit
The 6075 can be removed from its housing by pulling firmly on the black
front bezel. If a communication port is connected, it should be removed
first