Athena 6075 series, Instruction Manual, Page: 20 / 39

Locally Adjustable only (Not by Remote Keyboard)
10 -At- Auto-Tune Damping 0=Low, 1 =normal,
2=High
11 -cF- Configuration 0 to15
(See Note 4)
12xx -ct- Cooling Type 0-Oil or none,
1 -Air, 2-Water
13 -Id-
Unit ID CODE 0 to 99
(See Note 5)
14
-bd-
Baud Rates
300(0),600(
1)
1200(2), 2400(3)
15 -cL- Calibration, Low ±3% Span
(ZERO)
(°F/ºC)
16 -cH- Calibration, High ±3% Span
(SPAN)
(ºF/ºC)
xx Not on RTD units
When setting up the unit for the first time, push the “STAND BY" key
(LED above button is on), and the unit will be placed into an idle condi-
tion. Outputs and alarms will be off. On completion of inital setup, push
the key again (LED off) for normal operation.
press the INDEX key until parameter #9 (-cd-) appears in the process
display area.
a.
Set 14 in lower display to gain access to configuration code, by
pressing the up or down arrow and then pressing the ENTER key.
press the INDEX key until parameter #11 (-cF-) appears in the process
display area.
a. Refer to the configuration code chart and select a number that
represents the desired configuration of thealarms and display units
e.g., #06 = ºF, Deviation Alarms Alarm 1=Low Acting, Alarm
2=High Acting.
b. Set this number into the lower display, using the keys
c. press the ENTER key.
16
Note: Changing temperature scale requires re-setting of all points.
3.
4.
5.