® Copyright ATH-Heinl GmbH & Co. KG, 2013, All rights reserved. / Misprints and technical changes reserved / Issue: 09/2016
17
Utilization
The product is intended for lifting of vehicles. The corresponding technical data have to be observed.
1. Preparation
a.
Read all safety instructions carefully before operating the lift.
b. Lower the lift completely
c. Position the vehicle centrical between the scissors, pay attention herewith to the load distribution.
d. Put the rubber discs CENTRICAL under the original lifting points of the vehicle.
2. Lifting
a. Switch on the lift with the main switch
b. Lift the vehicle up to a height of 100-150 mm and stop the lifting by releasing the button LIFTING
c. Check if the vehicle is secure on the lift
d. Following lift further and observe the lifting process
3. Lowering
a. Check before lowering if there are any obstacles under the car
b. Press the button LOWERING
c. After reaching athe CE-Stop the button LOWERING must be released and then pushed again.
4. Completion
a. Lower the lift completely
b. Remove the rubber discs
c. Drive the vehicle from the lift
