ATEN VS0801HB, User Manual

Page: 22 / 31

Chapter 3. Operation
14
Enabling/Disabling the Standby Mode
The standby mode is a low-power mode where the port selection pushbuttons,
port LEDs, and IR receiver are disabled. To enable standby mode, press the
Power button on the device panel; press again to disable the standby mode.
When the standby mode is enabled, the port LEDs are immediately turned off,
and the Power LED lights green.
Executing an RS-232 Command
1. Make sure you have connected a hardware device (e.g. PC) to the
VS0801HB. For information on device requirements and installation, see
Optional Equipment , page 3 and Installation , page 8 respectively.
2. Send the command from your serial controller. For details on RS-232
commands, see RS-232 Commands , page 15.
Restarting the VS0801HB
Make sure to follow the steps below to safely restart the VS0801HB.
1. Power off the attached devices.
2. Unplug the power adapter cable from the VS0801HB.
3. Wait 10 seconds, and then replug the power adapter cable
4. After the VS0801HB is powered on, power on the attached devices.
Note:
When the VS0801HB is restarted, it selects the first port detected with a
powered-on source.