04
Guardian Monitor Center network diagram:
After downloading and installing the Guardian
Monitor Center on the computer*, use the IP address
of the "installation computer" to open the browser
interface for GMC.
Once the demonstrator installs the software, s/he can
use the monitor connected to the server computer
(with GMC installed) and the client on the notebook to
open the browser as shown below.
*Please see the User Manual for the actual software
installation procedures
After logging in and completing the device
configuration process (the GMC software will find all
GN0116 devices on the same network segment), the
notebook client can be used to view the status of all
GN0116 ports.
Sensors Installation
Ì
As mentioned in the Front View/ Rear View
introduction, the GN0116 mainly uses the four RJ-45
ports on the rear panel to connect to sensors or other
devices. Up to eight Digital Output (ports 101 ~ 108),
two Digital Inputs (ports 201 & 202) and six Analog
Inputs (including 4 resistor-types (ports 1 - 4) and two
voltage-types (31 & 32)) can be connected.
Note: The resistor-type and voltage-type ports must be
connected correctly or it will damage your system.
Guardian Monitor
Center Server
Client
GN0116 Guardian Over the NET™
Installation Guide