Hardware - Basic Installation
02
> Power Connection
1.
Connect one end of the bundled Power Adapter to
the AC power source and the other end to the AC
power source inlet on the rear panel.
2.
Turn on the GN0116's power switch.
The GN0116 supports two types of network
connections – over the Ethernet or through RS-232.
RS-232 can be connected to a modem to support a
Dial-up connection. It can also be connected directly
to the computer COM Port so commands can be issued
through the RS-232 Port or for setting the Logic
Configuration and Proxy function.
> Ethernet Connection
If the Ethernet connection is used, connect the
network cable into the RJ-45 port to connect the
GN0116 to the network.
Ì
> RS-232 Connection
If you choose to use the RS-232 connection, connect
the RJ-45 connector on the bundled RS-232-to-RJ-45
cable to the port marked as 232C on the panel and the
RS-232 to the corresponding device (Computer COM
port or the MODEM port); as the demonstrator is using
a notebook computer, an additional ATEN UC232A was
used to convert the RS-232 signal to USB so it can be
passed to the notebook computer through the USB
interface.
Note: You may choose between an Ethernet or RS-232
connection. If you choose the Ethernet connection
then there is no need to connect the RS-232 port.
GN0116 Guardian Over the NET™
Installation Guide