ATEN Altusen SN3001, User Manual

Page: 32 / 111

Secure Device Server User Manual
20
3. :Select the Secure Device Server in the Device List .
Note:
1. If the list is empty, or your device doesn't appear, double-check
that you have the correct network adapter selected and click
Enumerate
to refresh the Device List.
2. If there is more than one device in the list, use the MAC address
to distinguish your device. The Secure Device Server’s MAC
address is located on its bottom panel.
4. To check the IP address of the Secure Device Server or set an IP address
for it, respectively select Obtain an IP address automatically or Use the
following IP address .

For setting an IP address, fill in the required IP address, subnet mask
and gateway information according to your network environment.
5. Click Set IP . The IP address of the Secure Device Server is displayed in
the Device List .
6. Click Exit to close the program.
Without IP Installer (non-DHCP only)
On a non-Windows system, under non-DHCP network, users can assign a static
IP address to the Secure Device Server, different from its default of
192.168.0.60 , by following the steps below.
1. Set your PC’s IP address to 192.168.0. XXX , where XXX can be any
number except for 10.
2. Type the device’s default IP address — 192.168.0.60 — in your browser’s
URL location bar.
3. Log in with a valid username and password (see page 21).
4. On the Secure Device Server’s web interface, assign a fixed IP address for
it according to your network environment.
5. Save the settings and log out. After you log out, make sure to reset your
PC’s IP address to its original value.