ATEN Altusen KN2116VA, User Manual, Page: 193 / 301

Chapter 8. Device Management
175
Š
Adding Filters
To add an IP filter, do the following:
1. Click Add . A dialog box similar to the one below appears:
2. Specify whether you are filtering an IPv4 or IPv6 address.
3. Key the address you want to filter in the From: field.
Š
To filter a single IP address, click to put a check in the Single IP
checkbox.
Š
To filter a continuous range of addresses, key in the end number of
the range in the
To: field.
Note: This description is for the AP GUI. The Browser GUI differs as
follows:
1. It doesn’t offer an IPv4 or IPv6 choice. It only has From and
To fields for IPv4 filtering.
2. It doesn’t have a checkbox to specify a single IP address. To
filter a single IPv4 address, key the same address in both the
From and To fields.
4. After filling in the address, click OK .
5. Repeat these steps for any additional IP addresses you want to filter.