AWM-LR Page 3 of 4
5. Adjust the ball joint tension
6. Cable Management
4. Mount monitors onto crossbar
5.1.
If the monitors are not holding
position or are stiff to move, adjust
the tension plate by tightening or
loosening the three screws.
NOTE:
Adjust 3 screws
evenly
in small increments
NOTE:
Support the monitor
while making adjustments.
+
-
3mm
Hex Key
IMPORTANT!
Ensure enough cable slack is given to allow for movement of the monitors.
4.1.
Hook the top of the VESA
plate onto the ball joint mount.
4.2.
Gently push the bottom of the
monitor until the VESA plate locks
into place.
4.3.
(OPTIONAL) Tilt the monitor
upwards to install the security screw.
Tilt Up
Push
Click
Hook
Repeat steps 4.1 to 4.3 for second monitor
