Coin Mechanism and Pricing Troubleshooting Table
SYMPTOM
VGM accepts currency or
tokens, but number of
credits per coin or bill is
incorrect.
VGM won’t accept currency
or tokens.
VGM won’t start.
Audio and video are present.
Coin indicators don’t light
CAUSE
Improper settings at
Pricing Menu
Faulty wiring
Improper currency
Faulty coin
mechanism
Tilted coin
mechanism or VGM
Burned-out bulb
fuse circuit
REQUIRED ACTION
From Coin Options Menu, choose PRICING
OPTIONS MENU. Verify that units and credits
are set correctly.
1.
Check that cabinet wiring is correct for this VGM.
2. Assure that coin meter and coin switches
connect properly to control input wires.
1.
Unlock and open cash door. Empty cash box.
Inspect revenue for counterfeit currency.
2.
Check vault. Remove any items that block path
from mechanism.
1.
Unlock and open coin door. Check each
mechanism for proper mounting.
2. Remove mechanism.
3.
Clear currency path.
4.
Reinstall mechanism and latch it.
5. Enter Menu System by pressing and holding
TEST MODE switch inside coin door. From
Test Menu, choose CONTROLS TEST. Use
tests to confirm operation of coin switches.
1.
Verify that mechanism is level after doors close.
2. Repair or replace coin door if it is bent or
damaged.
3.
If necessary, adjust cabinet leg levelers to keep
mechanisms vertical.
1.
Burned-out bulbs mav
white or darkened.
Check continuity
2.
Replace burned-out bulb with same type.
1.
Check fuse continuity with DVM.
2.
If fuse is blown, replace fuse with same type.
3.
If fuse isn’t blown, check wiring.
CAUTION: Don’t remove or install any connector when power is turned on. Installation
under power will damage the circuit boards or hard disk drive and void the warranty.
7-2
2
Summary of Contents for San Francisco Rush 2049
Page 22: ...NOTES 2 10 ...
Page 46: ...L I J ...
Page 54: ...NOTES 3 32 ...
Page 89: ...SOUND I O BOARD ASSEMBLY JIu24I I I 1 I 3 I J 7 d mm II I I I UN2 a I GUN 1 A 1 6 7 7 ...