© 2008 AT&T Intellectual Property. All rights reserved.
AT&T, the AT&T logo and all other AT&T marks contained herein are trademarks of AT&T Intellectual Property and/or AT&T affiliated companies. All other
marks contained herein are the property of their respective owners. The information in this document is provided by AT&T for informational purposes only.
AT&T does not warrant the accuracy or completeness of the information or commit to issue updates or corrections to the information. AT&T is not responsible
for any damages resulting from use of or reliance on the information.
Automated Call Distribution Features (Contd)
REGISTER OR REBOOT THE PHONE
There will be occasions when you will need to reset your
phone so it can retrieve critical software updates and
configurations from the AT&T Voice DNA network. There
are three ways to do this:
z
If there are two wires connected to the telephone,
disconnect the power cord from the bottom of the
phone. Wait a few seconds, then plug it back in.
z
If there is only one wire running to the phone,
disconnect that wire. Wait a few seconds, then plug
it back in.
z
Or, you can press certain buttons onthe phone.
Register or Reboot the Phone (Models 320/330 and 601/650).
Step
Description
1
Hold down the
Volume Lower
,
Volume Higher
,
Hold
, and
Speakerphone
buttons at the same
time. The phone will make some sounds then the
Polycom
logo is displayed in the LCD window.
when the LCD window returns to its nromal state,
the phone will again be operational.
Register or Reboot the Phone (Model 4000).
Step
Description
1
Unplug the power or Power-over-Ethernet
cables from the bottomof the phone.
AT&T Voice DNA Quick Reference Guide — Polycom Telephones and Speakerphones - Page 15
