AT&T Network Adapter 25, Installation And Maintenance Manual

Page: 345 / 438

APPENDIX E: Administration Codes and Data
Table E-M. Port Administration, Trunks (Menu=1)
ACTION DESCRIPTION DATA
0 Physical port number CSSPP
1 Enter trunk port type code [See Table E-N]
2 Enter trunk number [0001 -9999;
0001-0104]
3 Assign class-of-service code [(DID–1-4; 3)
(All other—
See Table E-O; 8)]
4 Assign pooled facility access code. [Facility access code;
(100,101,102)
O if trunk not in
any group]
5 Allow dial access [l=Y/0=N]
6 Assign the trunk to a DGC group [1-32; 0 or none]
7 Make this a directed night service trunk
[1 Y/0=N]
8
Assign night service delay announcement [1 for first
announcement,
2 for second
announcement,
O for none]
9
Type of signaling on incoming calls [1=Tone/0=Pulse]
(Tie-Trunks only)
10 Determine pooled trunk hunting order of a
specified trunk {Read Only}
11
For Switched Loop Attendant systems ONLY: [0-7; 0=won’t ring
Priority of trunk to ring in queue† in queue/or
1=highest priority,
thru 7=lowest
priority]
Note: The TN747B CO Trunk port can be administered as either Ioop-start or ground-
start, but not both at the same time. If a TN747B is administered before it is installed in
a slot, the System 25 must be warm started before it will recognize the TN747B.
†
Not administrable for trunk port type codes 901-902 or 1003-1008.
*
Not administrable for trunk port type codes 901-902 or 1001-1008.
E-26