AT&T Digital Magic Messenger
FCC Notice
AT&T Digital Magic Messenger
Contents
The Federal Communications Commission (FCC) has established Rules
which permit this device to be directly connected to the telephone network.
Standardized jacks are used for these connections. This equipment should
not be used on party lines or coin lines.
If this equipment is malfunctioning, it may also be causing harm to the
telephone network; this device should be disconnected until the source of
the problem can be determined and until repair has been made. If this is not
done, the telephone company may temporarily disconnect service.
The telephone company may make changes in its technical operations
and procedures; if such changes affect the compatibility or use of this
device, the telephone company is required to give adequate notice of the
changes. You will be advised of your right to file a complaint with the FCC.
If the company requests information on what equipment is connected to
their lines, inform them of:
The telephone number this unit is connected to
The ringer equivalence number
The USCO jack required
The FCC Registration number
Items ‘b’ and ‘d’ are indicated on the label on the underside of the unit.
The ringer equivalence (REN) is used to determine how many devices
can be connected to your telephone line. In most areas, the sum of the RENs
of all devices on any one line should not exceed five (5.0). If too many
devices are attached, they may not ring properly.
a .
b .
c .
d .
Specifications
Recording Method: Adaptive Delta Modulation, 40 KBPS
Recording Source:
Built-in condenser microphone, AUX input mini-jack
Memory Capacity: 52 seconds total for day and night announcements
Power Failure Memory Retention:
2 Hours
Telephone Interface:
Standard balanced line tip and ring; 90V ring; ground
start or loop start
Power Requirements:
24V AC/DC, 0.5A maximum. Power supply included
with unit provides 24V AC @ 0.5A from 120V AC.
Battery Back-Up:
Ni-cad battery system
Inputs:
Power – 3-pin grounded DIN-type power jack, Line – RJ11-type
modular jack, AUX – 1/8" mini-jack for AUX input
Outputs:
Phone RJ11-type modular jack
Controls: ON/OFF switch, Loop/Ground start switch, VOLUME control, push-
buttons for MODE, RECORD, PLAY, ANNOUNCE (or MESSAGE)
Indicators:
LEDs for POWER, BYPASS/ANSWER RECORD, PLAY,
DAY/NIGHT
Mounting:
Shelf or wall mount. Mounting template and hardware provided
Dimensions:
8-1/8" x 6-1/2" x 2-3/8".
Limited Warranty and Limitation of Liability
2
FCC Notice
4
Specifications
4
Introduction
6
Front Panel Description
7
Rear Panel Description
8
Base Panel
8
Installation
9
Unpacking and Inspection
9
Installation Precautions
9
Connecting a Power Supply
9
Connecting the Magic Messenger to the Line Side
of a Telephone System
10
Connecting the Magic Messenger to the Station Side
of a Telephone Extension
11
Operation
12
Apply Power
12
Recording Announcements
12
Activate Bypass/Answer Mode
13
Select Day or Night Announcement
13
Operational Notes
14
Remote Operation
14
Care & Maintenance
The impact resistant housing and quality construction of the Magic
Messenger virtually eliminates the need for service and maintenance.
See Installation Cautions on page 9. For information on obtaining
maintenance and repair information see pages 2 and 3.
4
5
Summary of Contents for Digital Magic Messenger System
Page 16: ...AT T...
