EN 25
Faults table
When in doubt about the proper operation of your appliance, this does
not automatically mean there is a defect. Make sure to check the points
mentioned below in the table first, or visit our website ‘www.atag.nl’ for
more information.
If you have a doubt about the correct functioning of your oven, this
does not necessarily mean that there is a malfunction. In any event,
check the following items :
Query
Possible causes
What to do
The oven is not heating.
• The oven is not connected to
the power supply.
• Your fuse is out of order.
• The selected temperature is
too low.
• Plug in your oven.
• Replace the fuse in your
electrical set-up and check its
capacity (16A).
• Increase the selected
temperature.
* The padlock is fl ashing
• Problem with the door’s locking
mechanism.
• Call the After-Sales Service
Department.
The oven light is not working.
• The light is out of order.
• Call the After-Sales Service
Department.
*The pyrolysis cleaning cycle
does not begin.
• The door is not properly closed.
• The locking system is defective.
• Check that the door is locked.
• Call the After-Sales Service
Department.
Your oven starts beeping.
• During cooking.
• At the end of a cooking cycle.
• The recommended temperature
of your choice has been
reached.
• Your programmed cooking cycle
is finished.
The cooling fan continues to
operate after the oven stops.
• The fan should work for a
maximum of one hour after
cooking, or when the oven
temperature is greater than
125 °C.
• If it does not stop after 1 hour
• Open the oven door to
accelerate the cooling down of
the oven.
• Call the After-Sales Service
Department.
Warning
Repairs to your appliance should only be made by a professional.
Non-standard repairs may be a source of danger for the user. In all
circumstances, if you cannot deal with a problem yourself, contact the
After-sales Service Department without delay.
TROUBLESHOOTING
