GB 31
SYMPTOM
POSSIBLE CAUSE
SOLUTION
You have switched a cooking
zone on but the display keeps
fl ashing.
Th
e pan you are using is not
suitable for induction cooking
or has a diameter of less than
12 cm.
Use a suitable pan
(see page 13 and 14).
A cooking zone suddenly stops
working and you hear a signal.
Th
e preset time has ended.
Switch the bleep off using the
or
button on the timer.
Th
e hob is not working and
nothing appears in the display.
Th
ere is no power supply due
to a defective cable or a faulty
connection.
Check the fuses or the electric
switch (if there is no plug).
A fuse blows as soon as the hob
is switched on.
Th
e hob has been wrongly
connected.
Check the electrical
connections.
Fault code F00.
Th
e control panel is dirty or has
water lying on it.
Clean the control panel.
Fault code F0 ... F6 and FC.
Defective generator.
Contact the service department.
Fault code F7.
Th
e ambient temperature is not
good.
Switch off all heat sources in the
vicinity of the cooking plate.
Fault code F8 and F08.
Appliance over heated.
Th
e appliance has been
switched off because of over
heating. Let the appliance cool
down and start again on a lower
setting.
Fault code F9 and/or
continuous beep.
Th
e appliance has been
connected incorrectly and/or
the mains voltage is too high.
Let your connection be
changed.
Fault code F99.
You have pressed two or more
buttons at the same time.
Do not operate more than one
button at the same time.
Fault code FA.
Mains voltage is too low.
Contact your energy supplier.
Fault code FAN.
Air circulation not good.
Make sure the venting holes
under the cooking plate are open.
Other fault codes.
Defective generator.
Contact the service department.
General
TROUBLESHOOTING
