Atag CG9271MB, Instructions For Use Manual

Page: 60 / 70

GB 26
Symptom Possible cause Solution
Fault code E2 - The electronics have
overheated. Possibly a too
large pan was placed in the
front right cooking zone.
- The hob is insufficiently
ventilated.
- Let the hob cool down until
the code disappears.
- Make sure the hob is
sufficiently ventilated.
Spontaneous changing of the
cooking setting. - The pan is too close to the
touch controls.
- Keep the pan at a distance
of at least 2 cm from the
touch controls.
Fault code U400 Overvoltage, 400V appliance
connected incorrectly. Connect appliance according
to connecting diagram to the
bottom of the appliance.
Fault code Er36 Control panel overheated, the
pan is too close to the touch
controls. - Let the hob cool down.
- Keep the pan at a distance
of at least 2 cm from the
touch controls.
Fault code E7, Er13, Er20,
Er26, Er36, Er37 or Er39. Another defect. Contact the service
department.
Troubleshooting table gas
Symptom Possible cause Solution
There is a smell of gas in the
vicinity of the appliance.
There is a leak in the
connection of the appliance. Turn off the gas mains.
Contact the installation
company you employed.
A burner does not ignite. Plug not in socket.
Fuse defective/fuse in meter
cabinet switched off.
Sparkplug dirty/damp.
Burner parts not correctly
installed.
Push the plug into the
socket.
Fit a new fuse or switch the
automatic fuse back on.
Clean and dry the sparkplug.
Assemble the burner parts
using the centring ridges.
FAULTS